Mike Bulat candlestick demo coming February 11

An area for people to post information about upcoming events that might be of interest to WoodTurners.

Mike Bulat candlestick demo coming February 11

Postby normcloutier » Wed Jan 20, 2016 4:21 pm

WGNC member Mike Bulat will demonstrate how to turn off-axis candlesticks at the Feb. 11 meeting of the guild.

"The challenge with those candlesticks," Mike explains, "is that the disk is turned on two separate axis so you need to be very careful not to go too fast otherwise the disk will be disintegrated. Other challenges are finishing the bottom after the weight is added to the base using a four jaw chuck with a belt to avoid scratching the finish. Also sanding a multi-axis piece can be tricky."

The demo will begin at the usual 7pm meeting time at the NC State Crafts Center, and members and guests are all welcome. There will be an instant-gallery where members can have up to 3 of their pieces critiqued and photographed, and the usual raffel will be held at the close of the meeting at about 9pm.

bulatsample.JPG
bulatsample.JPG (11.48 KiB) Viewed 271 times
Mike lives in Wake Forest North Carolina and has been a woodturner for over 15 years. He studied under Jim Rodgers in California and in France with Jean-Francois Escoulen, attending two one week classes at the Ecole Escoulen School in Auguines France. Mike’s areas of interest includes multi axis turning, trembleurs and utilitarian pieces. He's a member of the Bay Area Woodturners’ Association and the American Association of Woodturners.

Mike retired in 2010 after forty-two years of working in the Industrial and Medical Gases industry. Once retired he volunteered at San Francisco Bay Area high schools teaching woodturning and taught a class on multi-axis turning at the Mount Diablo Adult Education Center in Pleasant Hill, CA.
ArtisticCandlestickDrawing058.pdf
(2 MiB) Downloaded 53 times
Artistic9Candlestick Instructions.pdf
(399.54 KiB) Downloaded 64 times
User avatar
normcloutier
Site Admin
 
Posts: 75
Images: 223
Joined: Wed Sep 24, 2014 3:07 pm

Return to Shows, exhibits & fairs

Who is online

Users browsing this forum: No registered users and 1 guest

cron